Free 200-105 Actual Tests - 200-105 Actual Dumps PDF - Dumps4download

200-105 Dumps With Real Exam Question Answers - Free 200-105 Study Material

Free 200-105 Exam Study Material - Get Updated 200-105 Braindumps Dumps4download

 Question NO:01 

Refer to the exhibit.
 

Based on the exhibited routing table, how will packets from a host within the 192.168.10.192/26 LAN be forwarded to 192.168.10.1?

A. The router will forward packets from R3 to R2 to R1.
B. The router will forward packets from R3 to R1 to R2.
C. The router will forward packets from R3 to R2 to R1 AND from R3 to R1.
D. The router will forward packets from R3 to R1.

Answer: C

Question NO:02

What are three valid reasons to assign ports to VLANs on a switch? (Choose three)

A. to make VTP easier to implement
B. to isolate broadcast traffic
C. to increase the size of the collision domain
D. to allow more devices to connect to the network
E. to logically group hosts according to function
F. to increase network security

Answer: B,E,F 

Pass Free Cisco 200-105 Exam in First Attempt | Dumps4download.co.in

Question NO:03

Which IEEE standard does PVST+ use to tunnel information?

A. 802.1x
B. 802 1q
C. 802.1w
D. 802.1s

Answer: B

Question NO:04

Which protocol is an open standard protocol framework that is commonly used in VPNs, to provide secure end-to-end communications?

A. RSA
B. L2TP
C. IPsec
D. PPTP

Answer: C

 

Valid And Updated 200-105 Exam Certifications Dumps Questions - Dumps4Download.co.in

Question NO:05

Which two statements about Ethernet standards are true? (Choose two)

A. Ethernet is defined by IEEE standard 802.2.
B. Ethernet is defined by IEEE standard 802.3.
C. Ethernet 10BASE-T does not support full-duplex.
D. When an Ethernet network uses CSMA/CD, it terminates transmission as soon as a collision
occurs.
E. When an Ethernet network uses CSMA/CA. it terminates transmission as soon as a collision occurs.

Answer: B,D 

Question NO:06 

Refer to the exhibit.
 

Which two statements are true about interVLAN routing in the topology that is shown in the exhibit?
(Choose two.)

A. Host E and host F use the same IP gateway address.
B. Router1 and Switch2 should be connected via a crossover cable.
C. Router1 will not play a role in communications between host A and host D.
D. The FastEthernet 0/0 interface on Router1 must be configured with subinterfaces.
E. Router1 needs more LAN interfaces to accommodate the VLANs that are shown in the exhibit.
F. The FastEthernet 0/0 interface on Router1 and the FastEthernet 0/1 interface on Switch2 trunk
ports must be configured using the same encapsulation type.
Answer: D,F 

Download Latest 200-105 Exam Dumps In Just 24 Hours - Dumps4Download.co.in

Question NO:07

Which command do you enter to view EIGRPv6 adjacencies?

A. show ipv6 eigrp 1 interface
B. show ipv6 route eigrp
C. show ipv6 eigrp neighbors
D. show running-configuration eigrp

Answer: C

Question NO:08

What does the frame-relay interface-dlci command configure?

A. local DLCI on the subinterface
B. remote DLCI on the main interface
C. remote DCLI on the subinterface
D. local DLCI on the main interface
Answer: A

Free 200-105 Exam Dumps - 200-105 Certifications - Dumps4Download.co.in

Question NO:09

Which two are advantages of static routing when compared to dynamic routing? (Choose two.)

A. Configuration complexity decreases as network size increases.

B. Security increases because only the network administrator may change the routing table.
C. Route summarization is computed automatically by the router.
D. Routing tables adapt automatically to topology changes.
E. An efficient algorithm is used to build routing tables, using automatic updates.
F. Routing updates are automatically sent to neighbors.
G. Routing traffic load is reduced when used in stub network links.

Answer: B,G


Question NO:10

Refer to the exhibit.

 

Assume that all router interfaces are operational and correctly configured. In addition, assume that OSPF has been correctly configured on router R2. How will the default route configured on R1 affect the operation of R2?A. Any packet destined for a network that is not directly connected to router R1 will be dropped.
B. Any packet destined for a network that is not directly connected to router R2 will be dropped
immediately.
C. Any packet destined for a network that is not directly connected to router R2 will be dropped
immediately because of the lack of a gateway on R1.
D. The networks directly connected to router R2 will not be able to communicate with the
172.16.100.0, 172.16.100.128, and 172.16.100.64 subnetworks.
E. Any packet destined for a network that is not referenced in the routing table of router R2 will be
directed to R1. R1 will then send that packet back to R2 and a routing loop will occur.
Answer: E

 Complete 200-105 Exam Dumps - Pass In 24 Hours - Dumps4Download.co.in